Features
・The duct nippers can cut the pillar section (up to 100mm long) between the side holes (wiring holes) of a wiring duct.
・The spring-operated handles require no pulling them back manually.
・The cutting edges are of pinching-off type that provides a smooth cut surface.
・The advantage in producing a cutting force permits a duct to be cut with a minimum force.
Application
The duct nippers are designed to cut the pillar section between the side holes (wiring holes) of a wiring duct.
Besides, it can be used to cut the gates deep inside a resin product.
Type
How to Use To cut in alignment with the lower ends of side holes:
 |
 |
 |
| Apply the tip of one blade to the lower end of a side hole. Turn the blade toward front while lightly gripping the handles.
|
Cut the pillar with the outer side of the blade facing straight in front.
|
The pillar can be cut in line with the lower ends of side holes.
|
Duct products
Tools
